Linux
無法使用 iwd 獨立連接到網際網路
我正在嘗試使用
iwd獨立連接到 WiFi ，沒有NetworkManager或wpa_supplicant。這是在 Debian 10 機器上，有
netinst安裝但沒有桌面環境。我將非免費組件添加到apt-sources並安裝了firmware-iwlwifi.我修改
/etc/iwd/main.conf如下[General] EnableNetworkConfiguration=true [Network] NameResolvingService=systemd我曾經
iwctl連接：[iwd]# station list Devices in Station Mode * -------------------------------------------------------------------------------- Name State Scanning -------------------------------------------------------------------------------- wlp2s0 connected [iwd]# device list Devices -------------------------------------------------------------------------------- Name Address Powered Adapter Mode -------------------------------------------------------------------------------- wlp2s0 xx:xx:xx:xx:xx:xx on phy0 station這些是正在執行的服務：
UNIT LOAD ACTIVE SUB DESCRIPTION cron.service loaded active running Regular background program processing daemon dbus.service loaded active running D-Bus System Message Bus getty@tty1.service loaded active running Getty on tty1 iwd.service loaded active running Wireless service rsyslog.service loaded active running System Logging Service ssh.service loaded active running OpenBSD Secure Shell server systemd-journald.service loaded active running Journal Service systemd-logind.service loaded active running Login Service systemd-networkd.service loaded active running Network Service systemd-resolved.service loaded active running Network Name Resolution systemd-timesyncd.service loaded active running Network Time Synchronization systemd-udevd.service loaded active running udev Kernel Device Manager user@0.service loaded active running User Manager for UID 0 LOAD = Reflects whether the unit definition was properly loaded. ACTIVE = The high-level unit activation state, i.e. generalization of SUB. SUB = The low-level unit activation state, values depend on unit type. 13 loaded units listed. Pass --all to see loaded but inactive units, too. To show all installed unit files use 'systemctl list-unit-files'.驅動已載入：
lspci | grep -i intel 02:00.0 Network controller: Intel Corporation Wireless-AC 9260 (rev 29)我在這裡看不到任何錯誤：
[ 4.807336] iwlwifi 0000:02:00.0 wlp2s0: renamed from wlan0 [ 5.330505] IPv6: ADDRCONF(NETDEV_UP): wlp2s0: link is not ready [ 9.815999] wlp2s0: authenticate with xx:xx:xx:xx:xx:xx [ 9.825148] wlp2s0: send auth to xx:xx:xx:xx:xx:xx (try 1/3) [ 9.868608] wlp2s0: authenticated [ 9.870031] wlp2s0: associate with xx:xx:xx:xx:xx:xx (try 1/3) [ 9.874042] wlp2s0: RX AssocResp from xx:xx:xx:xx:xx:xx (capab=0x1011 status=0 aid=2) [ 9.877212] wlp2s0: associated [ 9.976363] wlp2s0: Limiting TX power to 23 (23 - 0) dBm as advertised by xx:xx:xx:xx:xx:xx [ 11.900982] IPv6: ADDRCONF(NETDEV_CHANGE): wlp2s0: link becomes ready但我無法 ping 任何地址/主機名。
這有關係
dhcpcd嗎？有任何想法嗎？
通過升級到 Bullseye 解決。